Search results

Update - under security, I removed the mac address filtering and for some really strange reason that allowed my new cam to connect. Doesn't make sense, but after 1/2 a day I'm happy. Dan and Phil please feel free to delete this thread. I will do a writeup on the new 2347 vs. the old 2355 tomorrow.

I've got an I series NVR on firmware 4.50.000, with eight 2355 G1's attached. I just bought this 2347 to try it out. I simply removed one 2355 and attached the 2347, assuming the PNP would take care of it. On the NVR GUI it just constantly says "detecting IP camera" and goes nowhere. I did a...

Much appreciated Super Dave. The update link I looked at did not have the "2XX7" designation. Didn't even think to look at the UK portal.

Just purchased this camera as an experiment to see what it will do on a particular part of my property. There is *nowhere* in Hikvision's various firmware download portals showing firmware for this model. Is this just the standard G1 firmware, just like for the 2335 and 2385? If so, why doesn't...

So then you'll be signing out and not coming back, right?

Would a factory reset of the NVR help? Or would it remain bound to the Hik servers?

I found that when I had two cameras hooked up initially, the fan was quiet. As I added more cameras over the next few months the fan got louder, so it apparently is a variable speed fan according to load. There are some writeups on the internet about how to change to a quieter, aftermarket fan.

Basic motion detection is not good. Nobody uses it. If you use line crossing and intrusion detection ("smart events") and spend a little time tweaking them, you will be happy.

GP, try this: litedev.us.hik-connect.com just to see if it changes anything.

Another example of why everyone should prepare an email to themselves with all the important Hikvision information and save that email in a folder.

I have three Cat6 cables running from the attic of my home, through the inside of a breezeway, then into my garage. Two cables are for cameras, one is for an auxiliary wifi router in the garage. My garage is powered by a 220v line that is buried in the backyard in conduit and comes up into the...

I updated after JB's post. Day to day it's just the same. I've not explored the new features yet.

That's got to be the first time I've seen release notes with pictures!

I'm going to give it some time before upgrading. Please let us know if you experience any kinks.

That only works if it's just a camera that goes offline. If the NVR goes down it's not sending any emails.

There's no need for you to come in here and make sense!

This is what I have in my camera interface. Exact same as my NVR - grid pattern for basic motion detection. It's a G1, a 2385.

Yes it is. Here's a screen capture of basic events, motion, on my I-series running current firmware:

OK. What you're showing as "basic events" with drawing areas is for smart events - line drawing and intrusion - for the I-series. What Yupoert is showing is basic motion detection grids for the I-series. Been like this for years.

What you are showing is for smart events. What Yupowert is showing is for motion.