Recent content by OREO

This is the result. Ran the CMD prompt in administrator mode. Traceback (most recent call last): File "hikvision_tftpd.py", line 186, in <module> args.filename, file_contents) File "hikvision_tftpd.py", line 46, in __init__ self._tftp_sock = self._bind(tftp_addr) File...

I’ve disabled all firewall. AV has also been disabled. Currently running Win10 x64. The environment variables has also been set correctly. Can you share your working environment details?

For Scott Lamb’s tool, do you specifically need Python v2.7? The reason I asked is I came across your reply on this thread: https://www.use-ip.co.uk/forum/threads/hikvision-ds-7208huhi-k1-bricked-after-firmware-upg.3817/ and tried to follow through the instructions but failed with an error...

The NVR just passed the 3 year mark and knowing retailers, the first thing they’ll likely do is how much money can they make... Nonetheless I’ll give the retailer a call and see what they say this morning and if it’s ridiculous, I might just have to take the risk and try your method. Would be...

I think I would need to go down the TFTP route as I’ve tried the XML that HIKVision has provided but without a “user” account, I wouldn’t be able to get any further. Is the TFTP very difficult as I had a look and it needed python. Following through some commands, I got stuck and gave up but if...

It doesn’t allow me to change IP addresses and when entering password, SADP said incorrect password even though I know it’s the right password.

Software version V4.21.005build 190509 http Port 80 No. I didn’t save the GUID to a USB. When connected via VGA monitor to NVR, it allows me to enter a password but in the drop down, there is no user account. When connected to the same range, I can ping the NVR. Just not able to get IE to...

Hi StewartM, Thank you for the reply. The NVR has an IP address of 192.0.0.64 and is not accessible even if I’m on the same range. The NVR also has a status of “Active” Appreciate if you have any other ideas on how I can do a factory reset on it... Thank you.

Hi all, I’ve a NVR: DS-7608NI-I2 that after upgrading to a later firmware no longer has the user accounts nor admin account. It’s only allowing for passwords to be entered via GUI but that doesn’t work as the ok button cannot be clicked on. I am also unable to reach the main page of the NVR...