Recent content by lloydz1

Great to hear you have narrowed it down, defo go for the through plugs, if you do decide to replace much much easier. Here is a good video with a nice tip: In regards to the combine harvester I live in Wales on a small holding, have a little boy here who is tractor mad, with a selection of...

I feared as much, thanks for the speedy reply Phil!

Ok so I very much doubt the RJ-45 connectors will need to be replaced, it would just be the coupler or perhaps try this, sometimes when an installer would crimp the RJ45 connector on the cable they don't bend back the plastic arm on the connector. I usually bend them to a 90 degree angle from...

Are the recordings only failing during the night maybe when the IR's come on? Maybe this is taking more POE power Budget than your switch/NVR can provide? Have you tried powering the cams directly to see if this resolves the problem. If you are using a HIK NVR you could go into the Configuration...

Looks like you just need an RJ45 Coupler. The plugs should come out of both ends.

Hey, I have run about 50m of CAT6A 24AWG, and run this underground to a pole. I have a HikVision Speed Dome which takes a 24VAC 60W, unfortunately it doesn't take POE (which I thought it would) The camera is going to be mounted on a pole, but unfortunately the workmen who put up the pole...