Recent content by gianluca2

Thanks for the feedback...workk fine! :-) Now i need to understand how "grep" the status...if is recording state or not.. :-)

Thanks a lot for the message. I will test it again. Which software do you use to GET/POST messagses?

Thanks a lot for the feedback. This only works on NVR/DVR devices unfortunately.... :(

Good Morning Guys, I need to start / stop video recording and save on local SD CARD on my Cube Cam (DS-2CD2442FWD) using API. I have read the manual but seems that the command to register are based only on event (Smart, Line ecc). Any suggestion? Regards

Thanks a lot for your reply. I think is a firmware limitation....maybe due to cpu overload...

Good Morning, Using the web gui interface, im unable to draw more than one line detection. The menu box show only "1".... Any idea?

Good Morning, I have several DS-2CD2142FWD-I cam installed on my network but sometime, without reason the cam lose the Gateway IPv4 address configuration. Field Blank!! The DHCP is enable. I must reboot him, and the cam find again the gateway address. This situation is random and occur for all...